When a module is removed from the IP Server 900, the system will retain all programming information and configurations for the module. This is done to insure programming isn't lost because of a module needing to be replaced. This however can cause confussion when a card is placed in the wrong slot or is moved. To accommodate for this issue (as of SW version 25.1.2.9) a new option has been added that allows the module information to be removed at the next reboot.
The following command can only be entered by either ESI Technical Support through a terminal connection, or a Master Technician through WESP. This access control helps prevent accidental or inapropriate module removal.
Card <x> <y> u
Where <x> = Carrier Card on which the card is installed on and <y> = the module slot
Reboot System